X
items
Your shopping cart is empty.
Product Qty Amount
From:
Until:

Archive

Fuel for thought

[email protected]
Maybe I'm getting old but when I see racers the world over spending thousands of pounds (or dollars) on their winter engine rebuilds and then running them on ordinary pump fuels, I simply begin to wonder. By the time they have prepared the car, transported it to the circuit, paid the entry fee and fed and watered their little army of helpers, with any of the budget still remaining, you would have thought that they would have planned to fuel the engine on something just a little bit...
Read more

A load of hot air

[email protected]
It has often been said that I talk an awful lot of hot air. This comment, I hasten to add, is one more frequently voiced from members of my immediate family but this month, somehow and when associated with lube oil systems, the phase has much more of a resounding ring. This month therefore, I want to talk about the scavenge pump in a dry sump system and how big does it really need to be? The answer, as you might expect, is not that simple but let us look at what we are asking the scavenge...
Read more

Piston strength wins races

[email protected]

The colours may have changed from red to blue (Budweiser to Copart) at Kenny Bernstein Racing, but the objective never alters. The objective is to build bullet-proof engines that can go down the 1000-foot dragstrip quicker and faster than the car in the other lane. For co-crew chiefs Rob Flynn, Mike Guger and Todd Smith (who came over from Don Prudhomme's Snake Racing after that outfit closed operations at the end of the 2009 season), the objective is to fit the strongest piston...

Read more

All of a Flutter

[email protected]

A phenomenon rarely heard of these days, is that of ring flutter. Manifesting itself in the form of unusual wear characteristics and possibly high exhaust gas blow-by, particularly at light load conditions, ring flutter if left unchecked, can even cause pre-ignition/detonation of the incoming fuel-air charge, eventually leading to piston failure. The solution however, is not always that obvious. You may always hear that the root of the problem is all to do with the acceleration and...

Read more

Improving Surface Finish

[email protected]
In the last article on the subject of surface finish, we looked at some of the important reasons for providing a good level of surface finish. On surfaces involved in sliding contact we can help to ensure that the lubricant film maintained by the basic geometry of the components and their motion is thick enough to keep the high-points or asperities of the two surfaces apart by providing a smoother surface with less peaks, and also peaks which are of a lower height. We also noted that the...
Read more
RSS
First169170171172174176177178Last