In previous articles on the subject of crankshafts, we have touched on the benefits of compressive residual stresses. Two methods by which this might be introduced have been discussed, these being nitride hardening (nitriding) and fillet rolling, although there are many others, some of which will be discussed at a later date. By imparting these residual stresses to the surface of the material, there is a large increase in fatigue strength, which gives a greater factor of safety against...
Can you imagine waking up one day and not remembering where you are? I'm only too certain that this may have happened to many of you after the recent festivities but the experience is probably something you would prefer to forget. Perhaps then you might spare a thought for the feelings of an engine upon being cranked into life. Waking from its enforced slumber the camshaft will tell it when to open and close the intake and exhaust valves but who tells it when to fire the charge and...
A major consideration of any engine designer right from the outset is that of the cooling system. Even in the most efficient of gasoline race engines, only 35% of the fuel energy available is converted into mechanical power. The rest, something like 850kW from an engine delivering 450kW, is converted into heat which will need to be dissipated into the surrounding atmosphere. Putting it into perspective that's something like 280+, 3kW electric fires worth of heat, approximately half of...
As an engineer and a power unit engineer at that, many might say that I have little need of a dictionary. And in truth, since the vocabulary of engineering terms tends to be so exact and rarely found in all but the most comprehensive of lexicological texts, for very many years I have simply done without. But it was while thumbing the latest version of the OED (Oxford English Dictionary) - the concise version I hasten to add, and a present given to me only recently, when I came across the...
As many might know to your cost, the cylinder head gasket is high up among those engine components to suffer the greatest stress. Often a weak point in some of the best engine designs, its unenviable task is to provide a robust seal between the cylinder head and corresponding crankcase for the combustion gases, oils and coolant, both between each other and the outside atmosphere. If that were not difficult enough, the component also acts in distributing the dynamic loads between the head...